#TBS DISCOVERY PRO WITH CROSSFIRE UPDATE#

This is also now able to run 500mW+ once update is available. These are the new version v 1.1 that can be updated to read barcodes. SPECIFICATIONS Weight: 0.5g (receiver only) Size: 11mm x 18mm Requires: Firmware V6.14 Input. It packs up to 500mW of output power, and will ensure that your 50km flights occur without ever losing telemetry. UART2( used for rx by default, supports SBUS) TBS Unify Nano Pro32 v1.1 (25-500mW+) 29.95 USD. The TBS Crossfire Nano RX Pro is a higher telemetry output power option of the de-facto FPV standard receiver.

We will say ~7A FETs but this number isn't important for this class of quad.1S-2S operation (Max recommended motor is 1302.5 6400kv 2S).This latest board is designed to handle 2S as well but not huge motors. After over a dozen prototypes, we've been getting really good QC across order batches. Getting this thing right and reliable is exceedingly difficult and we've failed more than once in the past. In doing so, we've partly discovered why 1S boards are so unreliable. We've been working on this board for over three years now. In general it's risky flashing small boards. NOTE: If flashing this board, DO NOT PLUG BATTERY IN WHILE FLASHING!! The ESC's will burn. This board is specifically designed for the FPVCyle 13mm 11,250kv 1S motor but of course you can run whatever you like on it. Range of up to 30km / 20mi from the palm of your hand. CRSFShot for lowest latency and most direct response of any remote control available. The FET's are usually the limiting factor but on these tiny boards, the PCB is often more important. Ergonomic and compact design with comfy rubber grips.

Otherwise, the PCB on this guy has been specifically designed to handle the amperage needed for higher performance.

#TBS DISCOVERY PRO WITH CROSSFIRE FULL#

With a sensitivity of -130dB, full RF-side diversity, tiny receivers for FPV quads, the TBS CROSSFIRE contains the most modern technology to provide a superior long range control link. There are also separate volt and ground pads for both the Vtx and the camera so you don’t need to double up wires onto one pad. The TBS CROSSFIRE is a long-range R/C link based on the newest RF technology, capable of self-healing two-way communications and range beyond comprehension. You’re going to appreciate how large and accessible these solder pads are but this is still a tiny whoop board so you’re still going to need to be pretty careful soldering. Because solder pads are notably more efficient at conducting amps, we’ve ditched the connectors entirely.

This board was specifically designed to provide ease of use, reliability and performance for whoop and BabyTooth style 1S and now 2S builds with small motors of 1302.5 size and below. Check measurements if you want to use it for a Whoop. This board does not fit all Whoop frames.

Tbs discovery pro with crossfire